Play code from a text file.

Previous Top Next

1) Press Alt-F followed by O, then select a text file. This loads the text into the Source text  window ready to be played. Press OK after selection.


2) Select "Play text from code source window" in the code source selector drop-down list.




3) Click the Start button to start playing code. Pause stops code temporarily, you can start again where you left off. Stop halts code and sets the position to the start of the text.



Code is always played from the Source text window. If you select a different code source, such as random numbers , the text in this window will be replaced. You will need to go to step 1) above to restore the text from the file. To view what characters are to be played click on this toolbar button to display the source text.

. tasktextb2